deskthority

Hi,

now that I've got a Phantom PCB I need a plate. I know that there are dxf files on the wiki but I don't know in which size I should have them cut. They are way too small, when I just load them into AutoCAD. I'd like to use the ISO150 plate.

Can anyone please help me and tell me on which scale the plate from the wiki files should be?

Thanks, Nuum

PS: I hope this is the right subforum.

Units are probably in inches on the drawing files. Try scaling everything by a factor of 25.4.

That seems to be the right size, thanks!

And another little question: Do I get galvanic corrosion if I use a steel plate together with an aluminium case due to the contact between them? Or shouldn't I worry about that?