Page 1 of 1

Have a monitor without a stand ?

Posted: 05 Feb 2015, 13:38
by andrewjoy
Then get someone to knock you one together in 10 mins :)

With integrated macbook stand.

Posted: 05 Feb 2015, 13:41
by jacobolus
Sturdy articulating monitor arms are a bit pricey (the cheapest are like $60–70), but so nice to use.

Posted: 05 Feb 2015, 13:42
by andrewjoy
I only needed this and the built in stand was broken :)

Posted: 05 Feb 2015, 13:53
by bhtooefr
That said, I'm using a $23 Monoprice arm with my 20" IPS LCD, and it works fine...

Posted: 05 Feb 2015, 13:57
by Muirium
Keep the Mac the hell away from that nail!!

Posted: 05 Feb 2015, 13:59
by HzFaq
Nice fudge :D.

I've had one of these in my shopping basket for the last couple of months, it'll only be a matter of time before I crack.

Posted: 05 Feb 2015, 14:00
by andrewjoy
Muirium wrote: Keep the Mac the hell away from that nail!!
i will 3d print something to screw on there at some point for now the screw will do

Posted: 05 Feb 2015, 15:08
by DanielT
Use a cork, it's the best solution (because you also get to drink the wine :d )

Posted: 05 Feb 2015, 16:06
by Muirium
Wine in the office, so continental!

Posted: 05 Feb 2015, 23:39
by Mal-2
HzFaq wrote: Nice fudge :D.

I've had one of these in my shopping basket for the last couple of months, it'll only be a matter of time before I crack.
I bought something similar. On mine the arms are level, not stair-stepped upward, but functionally it's the same. It really was a nice move. For one thing, I mounted the monitors much higher than they were before, so they aren't leaning back. They're vertical, and that's nice when dealing with TN displays. This higher mounting means they also clear quite a lot of desk space beneath them which can be put to productive use. Here's my setup:

Image

As a bonus, I was able to use one of the newly freed-up stands on a TV that was previously wall-mounted and the original stand misplaced.

One bit of warning though -- if you set up the monitors even a little bit asymmetrically, the entire stand will lean slightly to one side. Then you either have un-level monitors, or level monitors at slightly different heights. Also, the rotation hinges don't lock, so bumping a monitor often means having to re-level it. My fix for that was to tape them together with electrical tape on the bezel. This also keeps light from sneaking in between them from behind.