Page 1 of 1
Question about the Soarer's converter
Posted: 15 Jun 2021, 16:59
by licrefin
- kbd_connector_ibmterm.png (4.07 KiB) Viewed 1580 times
- connections_teensy++2.png (202.4 KiB) Viewed 1580 times
As shown in the pictures above, IBM terminal keyboard has a pin called "PE" on the 7th. Where should I connect this one to?
In addition, in order to complete this converter, is everything I have to do is the following?:
1. Solder/Connect/Wire RJ45's 3, 4, 5, 6, 7 (pins) to teensy++'s Vcc, PD0, PD1, GND, [?]
2. Install hex in teensy++
3. Done
I would be grateful if someone can confirm myself if they are correct and the existence of the PE pin!
p.s) I am sorry if I am lacking out of some informations, since I still have no clear thoughts on these circuit works
Re: Question about the Soarer's converter
Posted: 15 Jun 2021, 17:56
by feltel
On my M122-conversions I never connected the PE pin.
Re: Question about the Soarer's converter
Posted: 15 Jun 2021, 18:16
by soyuz
PE is likely protective earth and not necessary to wire up to a controller board.
Re: Question about the Soarer's converter
Posted: 18 Jun 2021, 09:22
by licrefin
feltel wrote: 15 Jun 2021, 17:56
On my M122-conversions I never connected the PE pin.
Thank you for the opinion!
Re: Question about the Soarer's converter
Posted: 18 Jun 2021, 09:22
by licrefin
soyuz wrote: 15 Jun 2021, 18:16
PE is likely protective earth and not necessary to wire up to a controller board.
Thank you for the opinion!