Page 1 of 1
Finally got some!
Posted: 16 Nov 2020, 20:00
by hellothere
Specifically for the Enter key. (It's a BAE.) I do have the wire stabilizer. The keyboard came with only the one mount
.
What the hole looks like on the mounting plate.
The part. About 0.6 inches.
The part. About 1 cm.
The specific keyboard is a 1994 RT 101+Intel. FCC ID: AQ6-OAKZ15.
I'm in the Phoenix AZ area, USA. I'd gladly pay $2+ shipping for one. We can negotiate!
Thanks for looking!
Re: [WTB] NMB Hi-Tek 725 (Space Invaders) Stabilizer Mount(s)
Posted: 17 Nov 2020, 01:03
by Rayndalf
Let me check my parts bin, I have a fullsize space invader board I cut down to tenkeyless, so I think I have some extra stab clips.
Re: [WTB] NMB Hi-Tek 725 (Space Invaders) Stabilizer Mount(s)
Posted: 17 Nov 2020, 05:39
by Rayndalf
I think I have some, let me know if you need any replacement white linear space invaders or any of the numpad keys as well.
I really need to finish this cute little hack job sometime, but I'm not looking forward to the handwiring stage.I'm so bad at handwiring (only tried it before I learned about flux though
) that I should make some single key PCBs (like amoebas, only for space invaders).
Re: [WTB] NMB Hi-Tek 725 (Space Invaders) Stabilizer Mount(s)
Posted: 17 Nov 2020, 06:05
by 4_404
Rayndalf wrote: 17 Nov 2020, 05:39
I think I have some, let me know if you need any replacement white linear space invaders or any of the numpad keys as well.
I've been chasing a few spare white space invaders for a while, messaged.