Batspring Cases
Posted: 06 Apr 2018, 15:06
No more fighting with the fly plate!
Page 1 of 1
Re: Batspring Cases
Posted: 06 Apr 2018, 16:43
Replacement beamspring!
Posted: 06 Apr 2018, 22:39
That is the end goal. More work to do.
Posted: 06 Apr 2018, 23:06
This is great to see! Nice work!
Posted: 06 Apr 2018, 23:30
Very cool. I think I just came.
Posted: 07 Apr 2018, 00:43
Didn't someone also make a replacement PCB for one of the beamers not to long ago?
*-* custom beamspring boards soon...
*-* custom beamspring boards soon...
Posted: 07 Apr 2018, 01:06
Posted: 07 Apr 2018, 02:42
Make it MX-compatible. Because even if you manage to repeat the beamspring switch - where you'll get the keycaps? Don't tell me you'll print those too. Printed ones are shit 
Posted: 07 Apr 2018, 02:43
Posted: 07 Apr 2018, 02:46
Also there should be a place for RGB LED!
Posted: 07 Apr 2018, 04:27
I might be negotiating with a local chemical etching company to work on the metal side... I actually successfully 3D printed a full beamspring & flyplate out of plastic, but the response wasn't fast enough to actually be used. Shame.
When I build my first prototypes I'll probably just drop copper tape on the bottom of the 3D printed flyplate instead of doing stupid carbon/resin stuff.
When I build my first prototypes I'll probably just drop copper tape on the bottom of the 3D printed flyplate instead of doing stupid carbon/resin stuff.
Posted: 07 Apr 2018, 08:40
foam and foil even!__red__ wrote: I might be negotiating with a local chemical etching company to work on the metal side... I actually successfully 3D printed a full beamspring & flyplate out of plastic, but the response wasn't fast enough to actually be used. Shame.
When I build my first prototypes I'll probably just drop copper tape on the bottom of the 3D printed flyplate instead of doing stupid carbon/resin stuff.
Posted: 07 Apr 2018, 12:20
Oh..
You and DMA are all over the place with your fancy new stuff.:> Thank you for your contributions to the community ..both of you!