The Wyse 185 says hello!

[andrewjoy]

Oh Hi there, i am a Wyse terminal and i just wanted to say hi.

IMG_20150604_195844.jpg (929.21 KiB) Viewed 1578 times

IMG_20150604_195848.jpg (935.99 KiB) Viewed 1574 times

The plan is to do a full restoration , recap and calibrate the display. I will start a workshop thread when i start the process.

Oh i did not clean that board at all ! It must have had a cover on it as there is no shine whatsoever on the caps! 2 of them have yellowed but they looks like they have never been used , apart from the enter and space bar there was not even any dirt on the caps.

Does anyone know where i can get the plastic trim pot tools, i don't what to go anywhere near that CRT with a screwdriver ( apart from when i am discharging the tube).

[seebart]

Oh Hi there, i am a Wyse terminal and i just wanted to say hi.

Well hello there! You`re looking good. I´m sure Andrew will treat you good. Considder yourself a lucky Wyse! Looks like you`re a kitchen Wyse right now.

[andrewjoy]

So its just me that does all electronic repair in my kitchen ?

I so need a workshop / lab.

[seebart]

So its just me that does all electronic repair in my kitchen ?

I so need a workshop / lab.

if weather permits I do repairs outside. Repairs in the Kitchen? I might get in trouble for that.

[Redmaus]

Nice! I have been not seen a wyse terminal before.

I actually have this exact keyboard.

[DanielT]

Very nice I do repairs in the kitchen too ... sometimes

[andrewjoy]

Nice! I have been not seen a wyse terminal before.

I actually have this exact keyboard.

Except this one is bing used in its native environment . I have a wyse 50 and PCE as well I wish the PCE or 50 would work with this terminal may try it.